SET UP GUIDE

To connect AirLit to the GeoSmarPro app in a smooth manner keep in mind the below tips:

 

- Make sure in your mobile settings Geolocation is turn on.

​

- Your phone will need to be connected to the same network as the fan for initial set up.

​

- Be sure to have your phone, fan and router at a close distance from each other, for connection purposes only.

​

- Your router will need to be broadcasting a 2.4GHz network for the AirLit to connect. This is necessary for the setup process only.

​

​

GeoSmartPro App set up process

​

Follow the steps on the app to set up an account then follow the below steps:

​

1. Connect your AirLit to your power outlet, press the “60 sec” button for 5 seconds until the blue indicator rapidly blinks, then click on the confirm button on the app.

​

2. You will then need to enter your wifi password to connect your phone to the wifi router and connect to the internet.

​

3. Once you’ve entered all the details, you should see a ‘Connecting’ page, where your phone will try to link up to your AirGo smart fan through the wifi network.

​

4. Wait until your configuration is successful, then tap ”Complete” & Enjoy your AirLit!

​

​

Troubleshooting steps when the connection time out

​

This error is mostly caused due to the 5GHz set as a primary channel.

 

If you get a message of 'connection time out' follow below troubleshooting steps:

​

1. Clear Cache on the app, you can do this by going to 'Me' 'Settings' and reset the AirLit by pressing the '60 sec' button for 5 seconds.

​

2. Then log in to your router via IP, go into advance setting, wireless and turn off 5GHz.

 

3. Make sure that the 2.4GHz is broadcasting a Smart channel system and not only one channel.

 

4. After connecting the fan you can turn the 5GHz back on. 

​